Peli de Halleux
Peli de Halleux
Make sure that all the pins have been mapped properly. Check the values in ``config.ts`` against the schematics from Grand Central in Adafruit.
It’s usually the clocks. Where are your PRs? ________________________________ From: wallarug Sent: Tuesday, January 19, 2021 1:58:39 PM To: microsoft/pxt-maker Cc: Peli de Halleux ; Mention Subject: Re: [microsoft/pxt-maker] Adafruit...
A PR would be easier. ________________________________ From: lalauria2000 Sent: Tuesday, January 19, 2021 4:04:42 PM To: microsoft/pxt-maker Cc: Peli de Halleux ; Mention Subject: Re: [microsoft/pxt-maker] Adafruit grand central device...
Could you paste the link here?
It's SOS ... --- .... So something went wrong with the config or hardware. I think we have a guide somewhere to attach gdb and read the debug buffer, panic...
A PR would be great! ________________________________ From: wallarug ***@***.***> Sent: Saturday, April 10, 2021 5:01:26 PM To: microsoft/pxt-maker ***@***.***> Cc: Peli de Halleux ***@***.***>; Mention ***@***.***> Subject: Re: [microsoft/pxt-maker] Adafruit...
This "set pull pin up" happens implicitely when using the pin as a button. In https://github.com/Microsoft/pxt-maker/blob/master/libs/sparkfun-samd21-dev-breakout/device.d.ts#L181, the button is configured as active low / pull up. And in the button...
Ok i see now the confusion. When using "button D2 is pressed", we automatically set the pull up on the pin. However we use pin digital read, we don't set...
So "button D8 is pressed" set the pull up, "pin D8 digital read" does not set any pull.
“button D8 is pressed” does set the pull up on D8 (it should at least. I’ll check with a scope. Get Outlook for iOS ________________________________ From: bboyho Sent: Friday, March...