Paulo Borges

Hi, Antonio, If I change //SoftwareSerial serialSIM800; HardwareSerial serialSIM800; unsigned int resetPin; It fails to compile: exit status 1 Erro compilando para a placa ESP32 Wrover Module Do I have...

Hi, I did include it now. When I compile the sketch it returns: exit status 1 Erro compilando para a placa ESP32 Wrover Module Sim800.h is as below with all...

Antonio, this is the compiler's log. May be it can tell you something. Thanks ``` AVISO: a biblioteca ArduinoSIM800L-master alega rodar em arquitetura(s) avr e pode ser incompatível com sua...

Hi Antonio, I have never dealt with the internals of libraries but I am trying to figure out what may be wrong and I believe it is still something to...

Antonio, good morning. What I did was to delete the folder holding the previous library and used sketch/include library/add .zip library. Then recompiled the same sketch as posted previously. The...

Hi Antonio. Just tested, no more compilation errors, thanks. When run the sketch freezes as console display below: ``` Fat FS: Mount OK Loop starting.... File mount OK. Modem init...

Hi, thanks. I did not get where I am to include the `ftp.serialDebug();` but I made some other additions that might put some light on the reason for the problem....

Antonio, I have been looking into the code and try to understand things I am not familiarized with and I believe the problem is still related with the proper connection...

Hi Antonio, I had some time to try it again today and went back to your suggestion to use serialDebug(); I tried it inside my sketch but it did not...

Hi Antonio, I have the following test sketch and it is similar to this manual serial control you suggested. I tried but could not figure out why one works and...