Paweł Karpiński

I successfully force router to permit join by using raw command service, but I face another problem while adding device. Device was added, but ieee address wasn't know at that...

It looks like I restart HA before autosave was trigger, that's the reason of disappearing entity.

Workaround: In case of paring/reparing device with specific router. HA show duplicated entities, but after waiting **5min** after paring (to be sure that autosave happened) and restarting HA duplicates entity...

only message changed: > 2019-12-25 21:28:48 ERROR (ZiGate-Decode data) [zigate] Command 0x0100 failed E_ZCL_ERR_ZTRANSMIT_FAIL : b'' 2019-12-25 21:28:48 ERROR (ZiGate-Decode data) [zigate] Command 0x0100 failed E_ZCL_ERR_ZTRANSMIT_FAIL : b'' 2019-12-25 21:28:48...

Is it possible to add to the error information about related device?

W ustawieniach falownika musisz ustawić ID urządzenia, domyślnie powinno być "1", ale może masz coś innego. Falowniki mogą być połączone równolegle na modbus i dlatego na falowniku się pojawi infor,...

Pewnie by się dało dodać, a jaki masz przypadek użycia do "real time power control"? W sumie to tylko widzę sens przy instalacji off-grid, przy on on-grid nie widzę zastosowania.

Hard to say, depends how modbus was implemented (if modbus spec is the same).

First image which I tested doesn't have driver in it, but it works with emutos because it has driver in tos. So I tested with standard image 1.04 on hatari...

I've tested additionally with BL616 and 1.5GB image works, a little bit slow during image selection, but after that works as expected. It looks like it's ESP32-S3 issue only.