Paavo Pokkinen

Hitting the same exact issue. Without a plugin Kustomize with private remote base works properly, but with plugin enabled it does not.

Could add, that currently it is possible to create a sensor without eventSourceName, but it won't receive any events. This can be bit confusing.

_Subject_ is already set to event name, which probably is enough. Main issue I think is that _id_ cannot be given. As idea, do you think webhook endpoint could support...

I managed to replicate exact same issue where cloning of medium sized repository (70 megs) works fine with `https`, but does not work with `ssh`. It works fine for smaller...

In my tests (old model) when thermostat relay is on, it causes unit's room temperature probe itself to heat up to 2-3 degrees, which seemingly is not compensated in the...

Weird behaviour I noted with these MCU settings when i turn off the unit, and turn it back again, it starts to heat immediately when target is 22.5 and display...

Maybe I have wrong deadband setting in the thermostat, not sure. Seems no matter what number I input to it in settings, after refresh it always shows 1, and not...

I have also issue with the unit(s) heating internal probe when heating cycle is on. What I did is change deadzone temperature setting from 1 to 2 degrees, and temperature...

I'm thinking it might be best option to use floor sensor in the thermostat itself, and control the setpoint using external temperature sensor such as RuuviTag. Such control loop could...

@odelma Yes, that would also work. Use of the floor sensor depends on "sensor selection" choice you've made in the thermostat: https://github.com/fashberg/WThermostatBeca/blob/master/docs/BHT-002-Manual.pdf