Owen Williams

From the schematic you provided your hoverboard is based on a gigadevice chip: https://www.gigadevice.com/microcontroller/gd32vf103cbt6/ The hoverboards i have are based on the stmf103. Most of the hoverboard hacks (and firmware)...

So simplefoc supports some stm32 boards: https://docs.simplefoc.com/microcontrollers If you can work out how to flash your gd32 i suspect you could start to build your own firmware around simplefoc. It...

@happytm - is there anything we can do to help you on this issue. Otherwise I'll close. BTW: I've been using hoverboard motors with the STM g-b431g-esc1 board and it...

We really welcome people trying new chips!! The due uses a 32bit SAM3X8E chip which has a `analogWriteFrequency()` method. The SA3X8E is a type of SAM3XA chip so perhaps targetting...

I've tested this on stm32f405. Please, please merge. computeEulerAngles/qToFloat here works properly. Thanks @UT2UH and grumpy for fixing this. I was going nuts as the implementation in master is wrong....

I got the same error when I opened a folder which didn't have a platformio.ini file. When I opened the correct (child) folder it worked. It would be nice if...

@kaivalya97 - I'm in a similar position to you. I'd also like to help. It might be easier to discuss no kubeflow kfserving slack channel.

@per1234 - I've pushed a new commit with your suggestion. I've also moved the processing sketch because arduino editor seems to want to open the sketch because arduino has historically...

> Thanks @owennewo! I have one additional suggestion: the Arduino IDE has a quirk in that when you do a "Save As", it will only save certain files and folders...

@MichaelFBA I'm using the nano iot 33 which has no mag sensor. I chose it for the wifi - although mag would have been useful. Answer to your question -...