onley
onley
Is this discussion what led to the ModuleAddress command and if so would it be possible to expand this from 3 addresses? I am considering using these PZEM modules to...
Thank you, I will pursue the Tasmota PZEM driver, I thought that's what this was. Sorry.
I run linux on my laptop and before Astroarch had been using AstroDMX so that is what I am comparing on both the laptop and PI. Binning is 1x1 and...
I upped the driver usb buffer to 1024M and even set the upload folder to a ramdrive and down load time for full frame image is still 2.8 seconds.
The harddrive referenced earlier is a USB3 ssd and I set the upload folder from the indi driver for the camera to a ramdisk. are you suggesting running Astroarch from...
I've imaged the ssd to boot astroarch but the pi will not boot. I can boot from the sd card and mount the ssd partitions 1 and 2 and read...
I re-imaged on the pi itself and it now boots from SSD on USB3. Camera does 0.1 FPS in AstroDMX at 10ms exposure full res. For reference dd shows 591MB/s...
There was a problem with the first image, I re-imaged the ssd and it booted fine as I stated above. However while I can write 0's to the drive with...
The Frame Rate is less than 1 FPS on Raspbian as well. Either the Pi4 USB3 implementation is a train wreck or there is a problem with the ZWO drivers...
The Pi5 has twice the processor speed and claims an improved USB3 bus improvement. I have ordered on and am hoping I am not disappointed. I found a thread on...