ningpj

would like to confirm the physical setup to enable this with easy brd - i have tried with the jumper set to aux (PA7) and diag pin hardwired but cant...

> @nigelpjames I'm honestly not 100% sure about easy brd - I'm using [ fysetc/fysetc-erb](https://github.com/FYSETC/FYSETC-ERB) on my ERCF. > > The way I did the calibration was: > > 1....

Seeing more frequent load and prints abort with "!! No trigger on manual_stepper gear_stepper after full movement when loading to extruder"....will keep playing around and tweaking stall guard threshold and...

These "!! No trigger on manual_stepper gear_stepper after full movement" are a pain as they instantaneously abort the print...guess its not a problem when homing x&y but a major when...

After further research it appears the "!! No trigger on manual_stepper..." may have been due to my system still running with gear stepper microsteps set to 8 vs 16 to...

ok, net-net with stall guard enabled, any fault feeding filament through to the gearset that causes klipper to exceed the max homing distance will result in a "!! No trigger...

Dropping the current and restoring it would also allow people to run higher currents or more powerful steppers to drag filament through longer bowden tubes and less free running buffers.

Its pretty much a full reprint and rebuild as its a significant upgrade with allot of changes including encoder, selector cart (spring loaded servo), filament carts (wider, built in filament...

I just commented it out as safe_z should really be the safe floor and cant think of a use case that would require safe_z being reset to the current z...

"Adjustable fans" perhaps