tinycurrent

tinycurrent copied to clipboard

Stability issue

11

There might be a stability issue when introducing capacitive loads. This is seen on one of Dave's EEVBlog videos about the uCurrent (https://www.youtube.com/watch?v=1VlKoR0ldIE). The issue seems to be a design...

jricaee

Add screwless terminal block for input terminals (feature request)

7

For a future revision, It would be really convenient to have the input terminals (current) available on a screwless terminal block, to avoid the requirement for bulky banana-plug test cables,...

hattesen

Can change BNC connector type?

1

I see your tinycurrent connect to oscilloscope with BNC to BNC adapter. I see BNC connector( male type) on AliExpress.  Is it possible to use this connector...

MicroEP

DC accuracy in mA range

1

Maybe I am overlooking something here, but you use a 10mOhm resistor as shunt for the mA range. The slide switch has (according to the datasheet)

patzf

J5 battery connector specification

2

The [README.md](/nfhw/tinycurrent/blob/master/README.md) document specifies the J5 battery connector as _"2-pin 1.25 mm JST ZH style male header"_. However, [JST ZH connectors](https://www.jst.com/products/crimp-style-connectors-wire-to-board-type/zh-connector/) have a 1.5 mm pitch. While the J5 [male...

hattesen

I think it would be great if the tinyCurrent would allow measurement (in rare cases) higher than 1A. With the 5.5V power source, I understood the range would increase up...

lobodpav