nexysm

monitor blocked in wait_read

5

Hi all, i wanted to use buck50 in order to record a simple digital communication of 19.2 kBaud. I call monitor with the following command: `monitor rate=50k pb4-11=enabled printf="%2.5f"` At...

I have the following issue: When a step starts the actor attached to it isn't activated. Even the button of the actor is not green in the gui. When I...

cbp3 hangs for unknown reason

3

I have recently installed cbp3 and I am testing functionalities on the table. So, I have only one step in the HLT. When I start the step and then stop...

Can't configure trigger for edge triggering

2

I am using `logic` command in order to record a digital signal of about 19.2 kbaud and I want to set trigger in falling edge. I tried this: `$1.50: trigger...