nedievas
nedievas
I made a custom scheme of OpenTherm Gateway. Here's the schematics:  Constructed something like this:  Flashed with 1.4.0-rc.20. Results are that LED does not work. Maybe faulty schematics...
> Your heating temperature is set to 30 degrees. According to the table you provided, this is about 60 degrees at an outside temperature of 10 degrees. I don’t know...
> Hmm. It looks like we have to use other IDs to set the temperature if the curve mode on the boiler is enabled. For now, I can suggest disabling...
> So, let's go in order: > > 1. When PID or/and Equitherm is turned on, the temperature on the thermostat in the home assistant is limited to 5..30 because...
> Any news? I added the ability to use the temperature controller built into the boiler, but it needs to be tested. If my hypothesis is correct, then I will...
> Ok thx With the curve mode disabled, does the boiler correctly accept the heating temp and heat to the set temperature? Pls upload a screenshot of the graph `sensor.opentherm_heating_setpoint`...
> `sensor.opentherm_heating_temp` looks strange. This value should be smoother, example:  > > I have no experience with Danfoss Link, is it also connected to the opentherm bus? No. It...
> Ok. After the weekend, please upload screenshots of these graphs again.  Feel a lot chiller than before :) > @nedievas Kas tau neveikia su tuo boileriu? Aš turiu...
> Nustatymai iš HA: > >   Kai pajungti termostatą, katilas nebereaguoja į lauko temperatūrą. Taigi, tai nebeaktualu. Be...
> Pas mane gridinis 1 aukšte ir radiatoriai - 2. Visur Danfoss pavaros, zigbee jungikliai jas junginėja ir temperatūros jutikliai kiekviena kambary. Viskas suintegruota į HA. Šalčiausio kambario temperatūros jutiklis,...