John Tetreault (WA1OKB)
John Tetreault (WA1OKB)
I know this is an old thread.... but have an idea that may alleviate much of the concern over elevated privileges.... What if you create a systemd service who's sole...
I did do some further checking, since the output from cgps did not look correct to me, I set my GPS to send NMEA packets... so now the output looks...
Thank you David... No it's not fixed, I switched back to PBEACON, that's why it looks ok now. Here is the PBEACON line that works PBEACON delay=0:01 every=10:00 overlay=S symbol=\#...
Okay, I'll give that a try. I pared down the comment to just my call sign, so TBEACON line now reads TBEACON sendto=IG delay=0:30 every=60:00 symbol=\# overlay=S alt=1 power=13 height=25...
Even though it does say GPSD has a fix May 6 21:05:03 direwolf direwolf[2331]: GPSD: Location fix is now 3D. On Thu, May 6, 2021, 9:02 PM John Tetreault ***@***.***>...
So I did not build from source... The Raspbian repository has DW 1.6, and gpsd, so I installed from apt. I am running Raspbian Bullseye, so perhaps that is the...
Ender 5 pro, using Marlin TH3D unified firmware v2 on 4.2.7 Creality main board
oh, this was using the Cura Arc Welder plugin, not the one within Octoprint
Just an update on this problem ... I changed rx buffer in my firmware to 512. I'm running the latest THD3D unified Marlin firmware 2 on Creality 4.2.7 main board....
Thanks I'll give these a try... Fwiw, my latest test I removed Octoprint and the communication with the Pi from the equation... Sliced in Cura with the Cura arc welder...