Tim Curtis
Tim Curtis
Hi Paul, Since its not possible for the software to know much about users audio system, assume that if client defaults to sending 100% volume that full volume will be...
This is a sight for sore eyes :-) -Tim
Hi, I happen to have a DAC+ ADC and a quick test showed no issues at least on kernel 6.1.21 / Bullseye. Sometimes having a success case can help. Pipeline...
Sure, no prob. Using your ffmpeg example cmd I get exact same results as you did. As a data point the arecord command below worked fine with the DAC+ ADC...
Mandatory fields would help reduce trouble reports due to man's natural inclination to not read setup guides but displaying a link to setup guide would also be useful for those...
@kingosticks, yes it appears to be a regression compared to 0.4. I should also mention that setting `--initial-volume` to a value greater than 0 seems to work fine.
Mike, thanks for investigating. From a practical perspective, simply using the disable_sync option is a good solution especially for the usage scenario where there is just a single shairport-sync receiver....
I'm also seeing this error sometimes, but only on Pi5 with NVMe (non-boot) drive attached. ``` RPiOS: 12.9 Bookworm 64-bit | Linux: 6.6.74 64-bit (built with Pi-Gen) ii raspi-firmware 1:1.20250305-1...