Lauren Lagarde

Sorry about the wait, I didn't see this until just now. What operating system are you using? I was able to open all of the DXFs in master with LibreCad...

I'm not sure if this applies to your particular use case but you can often use Ctrl-[ as an alternative to Escape without the need for additional software.

I don't think this particular repository is active anymore. This printer is more of an experiment in the philosophy of RepRap then something that should be built with the intent...

Manually setting `inputs.nixos-generators.url` to `github:nix-community/nixos-generators/7c60ba4bc8d6aa2ba3e5b0f6ceb9fc07bc261565` seems to be a valid workaround for the time being until a tag/branch is added.