mgkiller7

> openssl speed -elapsed -evp aes-256-cbc -engine devcrypto I did see the same test result as yours， but i note the CPU load is very high: Tasks: 92 total, 2...

Finally i found out the reason why hang while type "rmmod wilc-sdio" after wilc_sdio_cmd52-failed . it is realate to a infinish loop"while (wait_for_recovery)" in wilc_send_config_pkt(), see my modify below: int...

Thank you very much, ajaykathat Sorry for my delay. I will have a try your advise.

Hi， ajaykathat After add the your modify mentioned above to drivers/staging/wilc1000/wilc_netdev.c，in most cases it help to success to rmmod wilc-sdio indeed. But when i do pressure test last night（my test...

Hi, ajaykathat Thanks for your reply. I can‘t observe any CMD52 error in the whole testing. My stress testing script is: ~ # cat /nvm/wilc_scan.sh while true do # install...

Hi，Mateusz-Gwara Thank you for your sharing. Your skill is good to determine whether the rmmod wilc-sdio in hang，after this hang issue happn then i can reboot my whole board to...

Hi, Mateusz-Gwara, ajaykathat Since update to the latest wilc driver&firmware, this issue never seen again. Best regards, mgkiller7

Dear @ajaykathat I am xiebluelike's teammate. Recently with slabtop i find that the main memory leak is from kmalloc-512 . so i run a test.sh and then turn on /sys/kernel/slab/kmalloc-512/trace...

Thank you for reply @ajaykathat Actually i am sure the memory leak from cfg80211_inform_bss_frame() at least 50 mintes not be freed, is that normal? enven thougt i think this leak...

Hi, AdhamAbozaeid can you get me a exact link to post this issue. The link you post above make me confuse.