mdkf

Possible race condition in onSucess in IMqttActionListener for connection status

2

I would like to send a message when the client connects to the broker. I added an IMqttActionListener to the connect parameters. About half the time. it works, the other...

MCU-LINK doesn't have MSD

1

Hello, I tried reflashing my MCU-LINK with both the bootloader and application from 0257. There is no MSD and the jumper location to get it to boot into bootloader mode...

The acceleration and deceleration values are not calculated correctly. Per the datasheet: steps/s^2 * ((2.5e-7)^2)/(2^-40) =acc

EEXT-10 Configuration error

1

Hello, I believe in the parameters for the Cypress HyperFlash is incorrect. The S26KSxxxS should be run at 166Mhz and the S26KLxxxS should be run at 100Mhz and at 3.0...

NetX should handle incoming 429 Too Many Requests HTTP response

2

If a server responds with a 429 code, the client should back off and retry again later. NetX does not pass this code to the end application, and just indicates...