mads0100

Enable nframe support regardless of orientation of device and set default steps/degree

7

Change the phase wires from 2 to 5 in order enable full control. Change the default steps/degree from 1000 to 55 per dev guidance.

Luban does not check for the capabilities of the least capable device. I set the 'highest' speed the rails could tolerate for a laser project, but the rotary module wasn't...

I started my print without filament in the right nozzle. It detected there wasn’t any filament, but the temp screen only showed the left nozzle temp and the buttons never...

Laser does not lift on pause

1

In 1.15.21, if using the 10W laser (unknown for the 1.6W) and running a 'print', if you hit pause, the laser no longer lifts away from the object. This makes...