luigir-it

After some trial and error, I guessed an answer to those questions, I'm sharing so that maybe it can help somebody 1. When you instruct btrbk to do a new...

I'm on Manjaro Linux. I had the same problem but setting baud rate to 115200 (stty -F /dev/ttyUSB0 115200) before starting prismatik didn't work. The turn off button just stop...

> allow_local_remote_servers' => true, Yes, this was the missing piece. Is it worth adding it to the documentation?

> I agree, the first solution is the most portable one. However, I think is a good thing to provide this `hyprland-session.target` file along with a patched `hyprland.desktop` and the...

What I meant, at least according to that wiki page, is that the two commands should be executed one after the other. This way, the target and all units that...

> the systray has changed recently and it's using ayatana-appindicator3/gtk3 so you are welcome to test it Sure, are you planning to release a new version soon? The current systray...

> Generally, it is recommended to use one of our projects, e.g. HyperSerialPico, which reaches easily around 4Mb. Yes, I should probably upgrade my current setup (old ATmega328p with ws2812b)...

> Yes, video source is usually 24Hz. But there is another extremely important issue: smoothing. This component of HyperHDR that creates a smooth transition between frames. It generates much more...

Since it does down-sampling, does it make sense to lower the capturing screen refresh rate? Or may it introduce lag? I tried with 20fps and don't notice much of a...

I'm sorry, where is the "light source" tab? I can enable logs in the "General settings" tab if that's what you mean. And the logs says dropped=0 `2024-05-21T15:33:25.259Z [PERFORMANCE] [INSTANCE0:...