lensherm
lensherm
My Spark shows up as a regular COM, but the Repair Tool is asking for a DJI Virtual COM. The DJI drivers with Assistant 2 are installed just in case.
@mtlynch, Question along these lines, but not quite: of course I could use a KVM switch feeding into TinyPilot, but that naturally allows only one remote machine to be visible...
Looks like the above was discussed at length, in an earlier issue.
Technically, if you add a simple MQTT broker, for example Eclipse Mosquitto, which happily runs on a Pi, you can interface with anything which talks MQTT, such as Tasmota smart...
@tomvanswam, firstly thanks for great work. Just so I don't go down a rabbit hole someone's been to already, does using a template for a calculated offset to dynamically smoothly...
Hi guys. Any updates on integrating Blueair into Home Assistant?
I installed homebridge, add the blueair plugin and configured for it to see and succesfully control my Classic 480i. I proceeded to add the HomeKit Controller to Home Assistant and...
By the way, Node-Red does work with air purifiers on HomeBridge. A little kludgy, but it seems to be not too bad. Just need to find me a bit of...
@pospielov , do you have an idea of approximately when an updated release might be expected?
> Hello is it possible to reroute DNS queries to an external AdGuard I already have AdGuard set up on my Synology system so I don’t need it on the...