AngryHunter88
AngryHunter88
I cant seem to getextruder a steps per mm to impact filament feed as well. When I change the extrusion value I seem to always under extrude by 25mm. I...
I'm still pretty new to the boxee and have not figured out the SQLite setup yet. But I guess the need to mark all movies as watched came up when...
Just wondering if there was any progress on this? Is there something I can do to help? unfortunately I am not very fluent in coding. Thanks
I tried adding -vvv to the Daemon_args and when I try journalctl -u CNCJs.SERVICE I get --no enteries-- Any other advice would be appreciated!
I can see after CNCjs starts that the ram slowly Kris fishing and after a couple minutes goes back down to approximately 10%. At that point CNCJs server seems to...
No that's the thing, my original image I had done some tinkering ( I believe you helped me on v1engineering site) So since I kept having issues with the UI...
@jeffeb3 could you try unplugging your CNC from the pi and clicking connect? I am playing with my pi in the house not connected to the CNC because it's easier...
Hey @jeffeb3 just following up I've tried another fresh image of v1pi and tried to get through a 1.5 hour cut. After about 45minutes CNCJs server seemed to stop working....
So I discovered that my eprom was from 2021. I have updated that firmware and currently letting run to see if that might have been my issue. I will follow...
I had to add all my drives to the exclusion list unfortunately