kskenyon
kskenyon
I'm using dlink.py to send dch-s150 motion updates to node-red through the python exec node. python3 -u /home/pi/dlink.py ***ip*** ***pin*** loop Exec node is triggered in spawn mode so it...
I have two new V1.3 TTGO-Lora32 and as far as I can tell everything is configured correctly but the display is either blank or not working. I know the display...
relay.three works with the write command but it will not work with the toggle command. I've reinstalled everything and relay three will still not respond to the toggle command. Kevin
I can access the console using 172.27.153.1 so I know it's working. I tried hard coding that into exporter.py but it won't take for some reason. I did setup.py build...
I'm trying to duplicate your Grafana pages from the JSON templates provided. Apparently there have been enough changes in Grafana since these were created that I can't make much work...
Does this have to continuously log to the homebridge log? Only status changes should be logged. The log fills up with useless information now. I don't see an option to...
I tried adding more pins by editing config.json in homebridge but I get an error starting up homebridge. I can't figure out why. Any ideas? It works fine without the...
My PSV5 failed and was replaced with a PSV6 without the ethernet ports. It is running on two dongles, one to my pi and one to the internet switch. My...