Keith Roberts

Several reasons: 1. It's slow O(N^2) at worst case scenario. Sometimes I have a Delaunay mesh I built in parallel and I want to do mesh optimization like Laplacian smoothing....

I appreciate it @nschloe 1. Yea, I am doing this with 500 million to 1 billion vertex meshes so slow is relative. Due to the pandemic, it'd be difficult to...

Hey Hamish, I don't think it's a bad idea. We've considered this in the past, but we've always stuck to a more a priori workflow based on linear waves. What...

Hey, Thanks! The color indicates the type of segment (ocean, mainland, or island). The variation in color occurs here because you're applying boundary conditions with the method ```make_bc``` using the...

Also, if you go the hand specification route, make sure to run ```m = make_bc(m,'islands');``` as this will apply island boundary conditions to, well, all your islands, which is critical...

You would call the method `msh.make_bc` repeatedly. I'm not sure I follow your issue with the prompt appearing and the figure. The prompt and the plot appears and then you...

The program will automatically append to the appropriate fields when called repeatedly AFAIR so there should be no overwriting. To clear the boundaries, type `m.bd = []; m.op` Perhaps there's...

How are you calling the `msh.make_bc()` method? If you call it like this `m = make_bc(m,'outer',1)` then the plot will appear first showing the boundary points `bpts` then it will...

thanks @HamishB perhaps we should create a folder called "mesh_checks" and put these one off functions there?

Yea, @jasonfleming we found that depressions sometimes occur when the mesh resolution is at the scale of man-made structures (~1-10 m) like underpasses, or for example a dredged dock that...