kecksk0enig
kecksk0enig
Hi! I stumbled upon this feature request while observing transdroid silently fails on tls rss feeds with selfsigned/not in default ca list certificates. maybe an 'allow any certificate' like in...
Thanks for the reply. i run ebusd from a docker container, passing --mqttvar="filter-direction=r|u|^w along the docker CL > root@529fe758fccb:/# ebusctl f hwc broadcast hwcStatus = no data stored ctlv2 HwcFlowTemp...
hm why would the hotwater be controlled by z1? id assume something like hwcopmode. also the value uf z1OPmode did not change at all when I switch the hotwater mode...
As statet above. the value of ebusd/cltv2/HwcOpMode does not change when setting the value on the MEH97/6. also if i change it with ebusctl w -c ctlv2 HwcOpMode 1 or...
This is still an open question. any suggestions to solve this are appreciated!
I've seen this too, solved it by using ip4 address on tvhguide. Did'nt know tvheadend was only serving @ ipv4. Found hint @ /etc/default/tvheadend #TVH_IPV6 #if set to 1 will...
I recently upgraded to latest firmware, since then I get wifi Disconnects way more often.the installation/position of AP and ebus adapter did not change. could there be a flaw in...
why isn't this included in 2.1?
i installed my v1 modul yesterday and everything worked fine (website /homeassistant/mqtt integration) however today the webfrontend wont load (or load only partially, control via homeassistant works)
6 wire, wifi is strong how do i look for OOms? /info and /inputs is also loading without errors