piwi

How to make Zeroconf available on all interfaces [eth0/wlan0]

7

Hi, I am playing with Zeroconf on an embedded linux system with a HTTP Server . All interfaces have DHCP running. How to configure Py-Zeroconf on all interfaces (eth0/wlan0) with...

TB Docker installation - Raspberry 5 fully utilized on all 4 CORES

4

**Component** * Installation * Generic **Description** Hi, I installed Thingsboard Docker version on a Raspberry PI 5 with 8GB RAM. The Rpi5 is completely utilized (~100%) on all 4 cores....

[HELP] how to send and test RPC Messages to a specific MODBUS device?

1

**Describe the issue** Thingsboard Server and IoT-Gatewayy runs on my local RPi5 device. I created a RPC request in the MODBUS Connector device to "Write Single Coil" with Type bits....

[HELP] how to implement datapoint discovery protocol for a customized connector?

1

**Describe the issue** Hi, I would like to create a new connector which is similar to Modbus RTU over serial but with a different workflow to set up data reading....

[HELP]MPU performance requirements of ThingsBoard IoT Gateway

2

-I am looking into creating a new Secure Gateway platform based on new i.mx91 / i.mx93. What is the requirement on CPU performance, RAM to run ThingsBoard IoT Gateway? -Additional...

Hi, at the moment I am using TB IoT Gateway Docker container. What is the best option to develop and test Customized Connectors efficiently without restarting complete container? Any hints...

Hi, is there a TB-Edge feature planned to set up Network interfaces e.g. wifi/ethernet/celluar, IP, DHCP setting via the WebUI?