Joakim Nohlgård
Joakim Nohlgård
@therealprof I discovered that NXP has begun providing pre-configured mcuxpresso packs for the Keil uVision pack installer, these files can be downloaded manually and unzipped without the Keil IDE as...
@soleilos most likely you need to update your OpenOCD version. It looks like your version is too old to support the stm32f7 CPUs.
The standard has been made available for free at http://standards.ieee.org/about/get/802/802.15.html in case anyone is interested in taking on this task.
I don't know where the proper place for such a check would be in the source, any pointers?
@tcschmidt I observed this happening between two RIOT nodes on the wireless 6lowpan network (using a sniffer) and there were never any ICMPv6 no route to host or any other...
There is actually a mention of the exact behaviour in [RFC6550 (RPL) page 100](tools.ietf.org/html/rfc6550#page-100) > Note that the chosen successor MUST NOT be the neighbor that was the > predecessor...
For the set/clear/toggle it seems like most MCUs have special registers for only setting or clearing GPIOs (as opposed to "writing" a value to the pins) to work around this...
@authmillenon fair enough
Some recent developments on Linux can be relevant here as well: - http://phoronix.com/scan.php?page=news_item&px=LRNG-dev-random-V2 - http://www.chronox.de/lrng/doc/lrng.pdf - http://lkml.iu.edu/hypermail/linux/kernel/1604.3/00029.html
It's still an issue, but we need to examine the pba-d-01-kw2x schematics to see what the best configuration could be here.