jetcat-bob
jetcat-bob
Actually, tried a compile of Marlin 2.1 this afternoon. Of course the display was not correct. Then I noticed I have the DACAI display and not a DWIN version. So...
Thanks Miguel for sharing this with me. I went back to my Creality 4.2.2 board because I feared there was a possible issue with the interrupt routines that was corrupting...
I never found a solution using Marlin sofware. I'm using my board with Klipper now. I don't use Klipper screen but I think the Raspberry Pi handles that anyhow. Sorry...
Yes it's a Voron 2.4 LDO kit. Two strips with 18 LEDs each. Each strip pulls 280ma. I was considering using a fan port on the Leviathan but I did...
Measuring with my DVM and not the iffy power supply, I get 20.8V @ 353ma. Full brightness @ 24V is 510 ma. There is a difference but I can live...
I don't have a spare fan output but there is a spare heater. I'll look into that possibility. Thanks for the suggestion! Bob Wilcox On Wed, Feb 7, 2024, 5:12...
The LED strips are 2 wire. They are not addressable. For my case, I'll use the the tool head heater output for the LEDs since the printer uses a canbus...
FYI, I did change the heater output 7.5 amp fuse (F1) to 1 amp.