Jonathan March

Results 17 comments of Jonathan March

Unreadably small plot axis labels on Dell XPS-15 laptop running Windows 10

@capn-freako not sure, but it's possible that @corranwebster will be AFK for the next week...

Unreadably small plot axis labels on Dell XPS-15 laptop running Windows 10

On the substance, xref https://stackoverflow.com/questions/69688867/how-do-i-access-the-base-pixel-scale-attribute-of-a-hastraits-chaco-enable-kiva

Added FAQ directory under docs, with several entries

@kjmcclaning - Lovely blog posts!! Yes, please feel free to post the link to the Enthought-Dev list (to be clear, the list is not a Digest, though you presumably have...

After 5-10 seconds, I have to press shift-enter to execute lines (instead of enter) and all lines take 5-10 seconds to execute.

@ccordoba12 yes, for now the Canopy GUI (hence its QtConsole frontend) still uses PySide, with IPython 2.4. However it sounds as if @ZGainsforth is working from Terminal, where either PyQt4...

After 5-10 seconds, I have to press shift-enter to execute lines (instead of enter) and all lines take 5-10 seconds to execute.

If you don't have the `pyqt` package installed (check `enpkg -s pyqt`), then you are using pyside. If you do, I don't know offhand which is the default, but you...

After 5-10 seconds, I have to press shift-enter to execute lines (instead of enter) and all lines take 5-10 seconds to execute.

And if you specify pyside?

After 5-10 seconds, I have to press shift-enter to execute lines (instead of enter) and all lines take 5-10 seconds to execute.

It's not a good idea to mix installation methods for a single package (in this case Enthought eggs and pip install), so I have no idea what mix of component...

After 5-10 seconds, I have to press shift-enter to execute lines (instead of enter) and all lines take 5-10 seconds to execute.

> QtCreator If there are references to it in your environment variables, try removing those before starting QtConsole.

After 5-10 seconds, I have to press shift-enter to execute lines (instead of enter) and all lines take 5-10 seconds to execute.

I think that's what he's doing -- the issue only applies to qtconsole in terminal, since in qtconsole in the Canopy GUI it uses ipython 2.4.

After 5-10 seconds, I have to press shift-enter to execute lines (instead of enter) and all lines take 5-10 seconds to execute.

> difference between these two. Yes, see https://support.enthought.com/hc/en-us/articles/204469910-IPython-Installed-version-in-the-Package-Manager-is-not-being-used-in-the-Canopy-GUI > Could you comment out those options and try again? +1