José María Martínez García
José María Martínez García
My Rostock Mini has a 180 mm rods. The M30 A command (after 7 or 8 hours and 100 iterations) said D= 178.72 but It seems work better with 178.80....
Mapembert... set precision greater than 0.5. 0.1 is tooo little
I'm using a proximity sensor and i'm getting the same "error" after 99 iterations. I'm using a switches for endstops, not optical sensor.
With the "testing" version and a proximity sensor and after 27 iterations, the program said that the printer was calibrated and... the printer was NOT calibrated. LOL Anybody knows how...
I'm using the "testing" branch and I haven't this problem. Be sure that the motors and the endstops are connected in the right position in the board, in the same...
I had the same problem, I saw this parameter and I changed it but now I don't remember. Later I'll see the font program and I'll send you the parameter...
After 6 or 7 hours, my printer ended at 99 iterations. I thing that 100 is the maximun amount of iterations. My printer was not calibrated. What is the latest...
Some thinks about it. 1) Delta Radius and Rod Length. Put a higher values. If you had a 180 mm rod, put 183 with M666 D183 2) Same for Delta...
After 15 hours calibrating the printer... it finished the calibration, but... with wrong parameters. I saved the parameters in EEPROM whith M500. Then I put... G30 and the bed measures...
D is the "arm length"? Or the bed radius?