itsme112358
itsme112358
I suspect that your system starts swapping at that point. tmp2 requires ~110 GB (of your RAM) leaving only 18GB for your system. Every thread can use ~500MB afaik, so...
Nothing is wrong, that's round about what I would expect from that kind of hardware 😅 I'll compare it with my smaller plotter: i5-9400 --> you have around 50% more...
What is "SSD" meant to be, is it a 500GB consumer SATA SSD or is it an Optane SSD? 😅 The "disk's" performance has already been an issue before madmax...
Also keep in mind you only have 18GB of RAM left. Each thread by default will be using up to 500MB, so with 16 Threads, you will be left with...
What SSD are you using? I suspect your SSD's cache is at its brim
That's something your OS has to handle / you have to handle via your OS Usually the software doesn't know or care about that. You can even run 20 threads...
Very interesting. There is another issue (#936) where someone complained about something similar, in that case I suspected he was going low on RAM and the system was starting to...
> For science, and because I got an additional 400TB of drives, I will test this with `-u 128 -v 128` from `-r 32` iterating +2 threads each run all...
The call of alc.exe is encapsulated in a Powershell cmdlet. As a workaround I now edited the begin and end blocks, but imho this is ugly and I don't like...
If that's the case, i fully agree 👍 No use in changing the behavior when the theoretically correct call never actually worked 😆