islonina

Hot-Plug ebb36 and octopus 1.1 466

2

What im missing. EBB36 and octopus on CAN all works fine but i need to manualy up the can0. I have file in interfaces for hot-plug: allow-hotplug can0 iface can0...

im using macro for mesuring only on print area. The only problem is that it mesure from nozzler distance not sensor so all mesurments are way off. What can i...

Wrong silicon tube in the manual

3

U cant use silicon from: https://fmic.pl/laczniki-silikonowe/193-5923-przewod-podcisnienia-3mm-vacuum.html The tube is 9.8mm OD

All connected ok. On esc only red light. Latest gui and fc firmware. All serian number show but on telemetry tab i got error that no motor is connected