Ingo Donasch
Ingo Donasch
In klicky-macros.cfg all references to docklocation_* are cast/filtered to the nearest integer. My dock was off by 0.4mm which caused the attach_probe to fail. The probe always was skewed by...
The top lip interferes with the corner clip by 4.1mm **FIX**: - In Panel move the history just before the mirror feature introduced in issue#8 fix (missing inserts in panel)....
The extrude feature is suppressed in the history....??? **FIX**: un-suppress the extrude feature for the "Extender" object and change its depth to -4.2mm. Also a 0.4mm chamfer would be advised.
 The hole is obviously at the wrong position. **Fix**: RearCornerTop::Sketch13 dimension[d274] should rather be 11.5mm from rear face, not 7.5mm from panel mount. 
Panel lower lip is superfluous and interferes with 1515 rail, see image  Fix: remove it from sketch2. SidePanels have no lip either and relocating it would require supports...
The "Panel" lacks the holes for the brass inserts on one side. The holes are also too big! Fix: - change Model Parameter:Panel:sketch1:Diameter Dimension-2 [d67] from 5.8 to 4.8mm -...