idlezombie
idlezombie
Just started doing a fresh setup first time using OZW. Experiencing the same crash as described above. First 8 nodes added without issue (all Aeotec ZW089 and ZW112). First crash...
Oh and also same error log in Event Viewer on every crash, different offset each time etc. but always same dll: Faulting application name: ozwadmin.exe, version: 0.1.75.0, time stamp: 0x5fa0fa79...
Further update, has continued to crash after adding nodes of ZW096, ZWA008, ZW132, ZW111. However interestingly did NOT crash after adding secure nodes ZW062 and ZW117. I think it also...
Just observed another detail in relation to this, it's not just when adding nodes it also happens when the controller is starting up. So if I open the admin program...
Have you set the qos in z2m? I saw similar behavior in hass with my aeotec dual nanos, they all started behaving a lot better after setting z2m config for...
And I do acknowledge that and I referenced your posts in that other issue about it. Perhaps I should re-phrase my suggestion a little. This wasn't so much about the...
Would also love to see this added.
Hardware thermals would be really nice if available as well, like what frezbo showed here in relation to raspberry pi hardware monitor. https://github.com/siderolabs/talos/issues/4491#issuecomment-1122239755