Morten Hattesen

I agree that modifying the `f` specifier can be problematic. Doesn't matter much what letter is chosen as the specifier for this "integer with decimal exponent" "decimal integer" or "pseudo...

How come nobody have even bothered to comment on this issue after 6 months? It is very difficult for M5 customers to work in an information vacuum, where fundamental information...

Reviving an old thread with some information. I am considering using this joystick for an HMI controller that will be used for industrial/medical equipment, located next to a 1.8" color...

Not received any reply on mail from 25 October. /Morten fre. 22. nov. 2019 18.21 skrev Thomas Hoppe : > @hattesen I have responded to your email > ages ago....

Nothing. Never happened before. Pls try [email protected] /Morten lør. 23. nov. 2019 21.57 skrev Thomas Hoppe : > I have sent it again to your medicool address, can you please...

@Ralim, I was unaware, that the tiptype was "known" to the firmware. In that case, it should obviously be detected, and the PID values adjusted accordingly. How is the current...

> The biggest temperature control issue right now is a non-linearity due to thermocouple placement (see #360). > Specifically, there are more than 5 seconds of thermal lag between an...

With reference to the discussion about automatic PID tuning in #444 I would like to make some suggestions that would be helpful in solving this issue. I would ideally like...

@dhiltonp, I'll see what I can get out of the data in the videos. Thanks for the details on the PID setup. One well-documented approach to solving time delays is...

I have had a quick look at the [code currently controlling](/Ralim/ts100/blob/449e21ae6580cbad15fdb5db8cba96f583f2ef73/workspace/TS100/src/main.cpp#L993) the (heating element) temperature. It looks to me like a pure P(roportional) control algorithm with an [added compensation](/Ralim/ts100/blob/449e21ae6580cbad15fdb5db8cba96f583f2ef73/workspace/TS100/src/main.cpp#L1003) using...