Pierre Brial
Pierre Brial
> Hi I do have the same problem did you find out a solution. Unfortunately not. I end up reading my device by using a script with gatttool and expect-lite....
I also had difficulties installing the MQTT server following the booklet, as it covers all the details, some not mandatory. Fortunately I found two tutorials : * with TLS :...
Same issue here with a Samsung Galaxy A50 and Android 11. Other mock location software work as expected (eg Fake GPS).
Hello Denny Sorry for the delay to answer. Your replacement parts seem fine. Let me know if it works. Regards Pierre
Hi Denny, You can omit the 10 ohms resistor. The 100nf helps to clean up the signal. Check with your scope if it made any difference if you remove it....
I also have bad results with an Aliexpress DCF77 module, which struggles to get time above 3 meters from the receiver. To be honest I still don't know if the...
Hi ispire2, Thank you very much for the feedback. About C vs C++, the main reasons for the choice is the simplicity of C and to not use the bloated...
Hello Ispire2, I don't find any harshness in your comments, which are very relevant. Could you give me the exact model of your Raspberry so I could add it to...
Hello pbrena thank you for the feedback. Don't hesitate to share the compilation error messages to see if it could be fixed.
Hi, Thank you for your nice comments. I read your WatchTower2 page, it is very interesting and I like a lot the clear explanations on the WWVB signal. It is...