Gilbo

> After using this script to setup the wireguard, I checked the /etc/sysctl.conf ,the ipv4/ipv6 forward are all not uncommentted,so I think the problem maybe related to iptables or ipv4...

Quoting https://wiki.debian.org/NetworkConfiguration: > The resolvconf program is generally only necessary when a system has multiple programs that need to dynamically modify the nameserver information. In a simple system where the...

This issue is unrelevant.. this issue was resolved at #262, look closely at the `if` statement before the `elif` you have referenced: https://github.com/angristan/wireguard-install/blob/469c2c58d63ac3140be44d9e9b6d35f074b97fcc/wireguard-install.sh#L130-L133 You can see that a check is...

Seems like you don't have the relevant packages installed, i don't know how you've gotten to this situation.. check if `/etc/wireguard/params` file exists. if so delete it and re-run the...

@jclehner I can send you the file via email if you would like to inspect it. I saw the commit 65624ddada8005ffc91dadc3d28cbd5377189850, so I guess this is not the first time...

> My email address can be found [here](https://github.com/jclehner/bcm2-utils/blob/master/bcm2cfg.cc#L3). Alright, I sent you the file. > Decrypting the file without a firmware binary won't be possible, unless it uses some pseudo-encryption...

Hey, it's been a while since I had time for this. But today I finally put my hands on this router again and connected to the UART consoles. 2 consoles...

For some reason I thought the whole project was released as opensource, now I understand that it is not fully open source, therefore it makes sense that this logic exists...

Just updating here in case someone else finds himself struggling with the same issue.. I did manage to succeed in installing a new Mach trap by extending the shellcode and...