Phil Malone

Similar issue. It seems that 11 should be supported on 18.04 ... but..... http://gazebosim.org/tutorials?tut=install_ubuntu I followed generic instructions here, and got the "Unable to locate" error.

When I went to the help page to find out....It says: Version 2019.1.1 built on Feburary 10, 2019..... which seems unlikely since it always shows the current date. I'm running...

I second this request. I like to maximize the width of the screen, which means that when I open up the source browser, all the widgets on the right size...

I'm sure this is a dumb question, but where does Commands.print() print to?

Just thinkking out loud here... There are some situations where loading a new RC App on the Robot Controller can cause/require the current app to be uninstalled and the new...

Hi I read this and was pretty surpized that I had never encountered it.... I will say that I have always beleived that STOP_AND RESET_ENCODERS did remove power from the...

There is a checkered history behind RESET_ENCODER (same as STOP_AND_RESET_ENCODERS) so this is a possible clue to this issue. Note: I wasn't suggesting a permanent switch to setPower(), simply proposing...

Perhaps check to see if that tablet has any special security provisions that can be manually enabled at the app level. For info... who makes that tablet, or is it...

Just stating the obvious here, possibly for others...... the Sample opmode ConceptAprilTagOptimizeExposure lets you interactively play with gain and exposure on a camera to observe the effects in real-time... (connect...

One solution is to calculate the velocity based on the changing encoder value. If you want to calculate the velocity each cycle, just subtract the previous encoder value (saved in...