Henk

icon indicating a website link www.pa3cqn.nl

icon location Groningen, Netherlands icon location Electronic engineer / Networking / graduated Artschool / licenced HAM. More interested in tinkering with things than making final build.

Results 4 comments of Henk

Support for frequencies below 76MHz

Technical possible for RDA5807, I extended my personal library to do so ( 50-76, and 76-115 ), and to tune with direct frequency input with 1 kHz resolution for HAM...

pll not recalculated ( 150 MHz boundary ?? )

2.1.2 , so the latest. But other versions before that had the same problem. It's on AVR ( the arduino env ) . High Freq are not a problem. The...

pll not recalculated ( 150 MHz boundary ?? )

@ Jason Seems indeed to be two different things. The first part about needing a pll-reset when doing a switch from F>150 to F 150 , the other clocks on...

Frequency Set Failure with Sequential Setting of Clk0 and Clk1

I ran into this too and just a thought: if you change sequentially and the clk1 is > 100 and the new clk0 >100 clk0 will not be set because...