Mick

just to let people know.. i now have this working .. have updated my fork of it if people wanted to try it ? .. can issue PULL REQUEST ?...

depends on you current set up, you could trail it?.. if your HomeAssistant is running on the same setup where you have your inverter plugged into it, you can use...

i forked this a while back, and edited it WITH a unique ID, so its easier to set up TWO inverter on same MQTT / location etc ... ive just...

have you tried this using this at all ? i would imagine you would need to have them both connected separately, with two instances running ?? have you tried just...

Do you have the Watchpower program working with this inverter ?? If so you could use that to sniff the protocol it's using a etc....

not sure why you tried with the raw command of Tnnn, and ^P00X the inverter_poller program will create the checksum etc... so the following should work .. inverter_poller -r PID...

this project is designed around MQTT protocol... which HomeAssistant then picks up and uses... so depends what you wanted to use as a client to display the information ...

MQTT is not just a communication between docker and HA, it can be used remotely too... so with DOCKER on say a PI zero at the Inverter, the HomeAssistant server...

not looked at manios repo... but was also having problems getting it to capture the data, with error of "reply too short errors" etc... i found #20 were he also...

just to try an answer this... simple answer is NO .. Long answer is no its not been implemented (yet) make sure your using the PN532 as a reader, using...