Francois Polito

Results 3 comments of Francois Polito

Gap between box and holding tray

Hi, Thank you for your comment. There is a parameter called `tolerance` in the file _ikea_skadis.scad_. You can set this value to your preference to adjust the gap. If you...

Gap between box and holding tray

Thank you for your input. I might consider your suggestion on an upcoming iteration. At the moment, you could play with the perimeter and infill settings of your slicer software...

allow for squared corner plates?

Thanks for sharing your ideas! I think I understand what you're aiming for, but I'd love a bit more detail to make sure we're on the right track. Here are...