Gauthier Brière

hi @henpemaz, Thank you for raising this behavior... Yes, I will add this topic in the todo list. Actually, the only solution is to calculate the number N of revolutions...

Bonjour [Jean-Claude](@Flying-Hammer), Ben parce-que $H effectue la prise d'origine (homing), c'est à dire un double déplacement jusqu'à activer les commutateurs de butée des axes. Et là, on ne veux pas...

Oui, mais `G0A0` n'est qu'un exemple parmis tant d'autres... Un autre exemple pourrait être `G1A2` si on a besoin d'usiner jusqu'à un angle de 2... Les besoins sont infinis, et...

Bonjour, _(Traduction exceptionnelle de courtoisie en Anglais ci-dessous...) (Exceptional courtesy translation to English below ...)_ Vu qu'ici, nous sommes, sur les pages concernant les problèmes du projet dont JE suis...

Hi @thawkins, Thanks for your interest in grbl-Mega-5X and proposing this evol. In your pull request, don't forget to add the config.h #define items for enabling thoses functionalities, the code...

Hi @bestiada It probably a good idea, but rather bit complicated... Serials coms are handled by interrupts which have priority over the running code... So, before we can coding this...

Hi @sinfocomp, The normal operation of the hold mode in milling machine is to leave the spindle enabled. So, there is no code to restarting the spindle in the resume...

Hi @sinfocomp, Since I am newly retired since a little bit less than one year, I have much less time available than before :smiley:. Sunny days were much more conducive...

Hi @atomino-max, Curently, it's not possible to have both spindle and laser connected and switch with grbl command ($32 or other...) it' in the todo list, but I don't know...

HI @IgnacioZeus, grbl-Mega-5X is specially written for Arduino Mega and RAMPS 1.4. The laser driving is a standard functionality of it. You can use LaserGRBL (https://github.com/arkypita/LaserGRBL / http://lasergrbl.com) to drive...