Emil
Emil
> T0 is NOT responding on my E3D amplifier with PT100 sensor > I use PF8 from EXTENSION1 as signal pin. > I use GND and 3.3V from a free...
> That does not sound right. Froze up when connect the amp to the T0 input? I think it can't froze up when connect the amp board to the T0...
Thank you very much guys. Did anyone tried connecting max31865? If yes how? I'm quite dummy in all of this .And which board is more accurate? The reason I'm asking...
> The Adafruit PT100 board do work fine for me as well as the E3D Pt100 board What type of stepper drivers do you use , do you use spi...
thank you very much sir. in your config file it says PF9 for temprature sensor. but in your comment it says PF8. that what i was wondering because in pins...
do i need to remove pull up resistor?
thank you very much guys for great support
Definitely it's a firmware mistake, it initiates error with out checking BIGTREETECH-TouchScreenFirmware-master\TFT\src\User\Menu\menu.c line 63: static REMINDER reminder = {{0, 0, LCD_WIDTH, TITLE_END_Y}, 0, STATUS_UNCONNECT, LABEL_UNCONNECTED}; there is no if or...
thank you mine one at the moment is set to 0