e-caliskan

To go back to the old version (Original_OTA_Xiaomi_LYWSD03MMC_v1.0.0_0130.bin ); To do this, you must remove your temperature sensor and connect it with the cables by following the steps below. This...

> @VonalOrdu > > 1. The contact on the PCB marked as "reset" is not an RST signal for the TLSR825x SoC ! > 2. https://pvvx.github.io/ATC_MiThermometer/USBCOMFlashTx.html - does not use...

> The very name of the utility describes: _TLSR825x USB-COM Flash Writer v0.4_ (**TX-SWS only!**) :) > > The picture is from another version of the programmer - https://github.com/pvvx/TlsrComProg825x -...

> > Are you saying that I am enough like this? > > Yes `python.exe TLSR825xComFlasher.py -p COM3 -t 70 wf 0 Original_full_flash_Xiaomi_LYWSD03MMC.bin ` Why didn't this method work? "Chip...

To go back to the old version (Original_OTA_Xiaomi_LYWSD03MMC_v1.0.0_0130.bin ); To do this, you must remove your temperature sensor and connect it with the cables by following the steps below. This...

> Too much time in this loop without `yield()` => WDT ? > > ```c++ > while (WiFi.status() != WL_CONNECTED && attempts < 60) > { > wifiLedUpdate(); > delay(500);...