dp111
dp111
On the CM4 we use the BCM54210PE and the SYNC_IN and SYNC_OUT are exposed to pins on the CM4 connector. The CM4IO board exposes these signals on connector J2. @jaycordaro...
I have the hardware to test this ( scope and lots of different led tape ), but not the expertise to get this to build. Happy to test is someone...
I suspect the issue is the host isn't driving the bus high to charge the capacitor at the correct time. This may have worked in the past by luck or...
Did you see the bit in the link which says the temperature conversion takes extra current and so needs a stronger pull so they recommend that the host drives the...
That's good. It might be worth checking the timing is correct. On Wed, 22 Mar 2023 at 13:13, Phil Elwell ***@***.***> wrote: > That's what the w1_gpio driver attempts to...
I'll probably leave this pull request until you are a little further on with this.
Latest beta here [https://stardot.org.uk/forums/viewtopic.php?f=3&t=19513&p=366874#p366874](url)
I'll probably leave this pull request until you are a little further on with this.
I've recreated this issue. It turns out that it is something we have also been investigating. The easy fixed as you have found is to add a resistor to ground....
Emulated BBC Micro on one Pi, with Emulated Tube, to talk to PiTubeDirect processors on a second Pi?
The closest thing I know of : https://stardot.org.uk/forums/viewtopic.php?t=21985 Dominic On Sat, 13 Jul 2024 at 07:45, David Banks ***@***.***> wrote: > Hi Graham, > > Sorry, I'm not aware of...