Doug Scott

icon location Ajax, ON icon location Non-programmer beyond building firmware, but then again, it was my 6 year old niece that taught me.

Results 3 issues of Doug Scott

G29 gives probing failed error message

1 comment

I recently installed a new MKS SGEN LPC1769 board in my 3d printer. I just installed a completely new source environment using an archive that was downloaded April 12 of...

G28 fails to home z axis

1 comment

I am running a MKS SGEN_L V1.0 with a BTT TFT35E3V3.0, MKS TMC2209 drivers in UART mode, and a 3DPROBE. Using Marlin 2.0.7.2 and current version of firmware in Touchscreen...

Using second z-axis port on motherboard

8 comment

I am trying to correct an issue I have with running the z-axis stepper motors through one port. This motherboard has a second z-axis connection that I am hoping will...