Antonino Di Guardo
Antonino Di Guardo
I tested it on a ESP-01S and ESP-12S both connected to TFT at 500000b/s with no issue
Made some measurements. A file of 1,106,458 bytes uploaded in 27:30 minutes -> 1,053KB/s of transfer rate. Same rate for small files (e.g. 120KB -> 0,99KB/s).
yes, it is needed only to add support to M28 SD: (for TFT SD), M28 U: (for TFT USB)
> You may be interrested on this #575 MKS protocol allow up to 100KB/s interesting. But are you working to add it in the ESP3D fw? TFT seems not involved...
ok. I have a BTT TFT35 V3 and MKS TFT28 V4 eventually just to make some testing. As far as I see, the MKS Wifi module has IO0 and IO1...
@Mech131 and @all As reported here https://github.com/bigtreetech/BIGTREETECH-TouchScreenFirmware/issues/2536 try to: - disable ADVANCED_OK (in Configuration_adv.h) - enable BLTOUCH_SET_5V_MODE in Configuration_adv.h (this should solve the issue)
@PSCY and did you also enable BLTOUCH_SET_5V_MODE in Configuration_adv.h?
@Mech131 if the suggested changes are not solving the issue then it's probably a bug introduced in Marlin fw.
> > When printing "over USB cable from slicer" where is the USB cable connected to? > > the USB cable is directly connected with the MKS Gen L 1.0...
> > > > When printing "over USB cable from slicer" where is the USB cable connected to? > > > > > > > > > the USB cable...