Tim
I like the idea of the trough hole usb connector. Jlcpb is not able to mount any usb connector so some solution is needed anyways. It would be a huge...
Another component that is bizarrely missing from jlcpcbs catalogue is a proper power inductor, btw.
Yes, but most components will stay as "extended", which means there is an additional set up fee. It makes a lot of sense to redesign to only use "basic" components....
It's $3.00. Does not sound much, but consider that they will assemble a maximum of 5 boards. So each board will be $0.60 more expensive for every non-basic part that...
But it's not an issue, since the "lite" design (see EEV forum) is only based on "basic" components.
Well, I frequently use their service and two weeks ago it was still limited to 5 for discounted orders. Panelizing is something that would help, but easyeda does not support...
There are also the header for the programming, which is through hole. The crystal is optional anyways, since the MCU is able to synchronize from USB.
>In case this needs to be identified as a board variant I conntected PB8 to GND in the design. I posted a changelog in the EEVblog thread. We should probably...
Hi kasbah, I also responded on EEV forum. I am still a bit confused with which part Kitspace would exactly help? Only collecting orders or also redustributing them? I think...
hi @kasbah, indeed, waiting for your mail then. Regarding sharing of any leftover money, I guess we'd need to figure out something that helps the community. I certainly would not...