Colin Smith
Colin Smith
I'm seeing this as well. It started after a fresh install of Rasbpian Buster, Pi-Hole, and PADD a little over a week ago. My previous installation didn't have this issue.
I started over with a new flash of the latest Raspbian Buster (8/20/20), Pi-Hole, and PADD and the problem has not re-occured.
I should clarify. I _like_ the speed, but I can see where the noise could be problematic. Perhaps a stealth mode?
> Higher speed applies only for 24 volt printers, so MK2.5 is not affected. We plan to add silent mode. Awesome! Thanks!
I agree with this. I'm a noobie...is there a way to configure the way the messages are displayed? Thanks, --Colin
OK, somehow got the configuration to work. I put the sample config on the front page into config.yaml. Something then modified it and took out all the comments and set...