Connor Workman

Results 3 comments of Connor Workman

Fusion360 rotary cnc with origin placed properly at the top of the stock leads to errors in B code.

> I think Fusion 360 can only perform post-processing correctly if the axe is in the center of the cylindre. I've been told by the people over at fusion360 that...

Fusion360 rotary cnc with origin placed properly at the top of the stock leads to errors in B code.

> Snapmaker is based on Malin GCode and actually, both commands are not defined in it. I'm not sure Snapmaker developers plan to improve Marlin. This is not a new...

Crash in fabscreen following run boundary

I just had this same error happen with fusion360, Luban 4.8.2, Snapmaker 2.0 A350 V1.16.7. Is there an actual fix to this @voidrin ?