Colin O'Flynn

The firmware is copyright material, and should **never** be shared (or even links to such material submitted). People doing so would jeopardize the entire project. Note that the same SW...

Devices _appear_ to operate fine with FW from one device flashed onto another (i.e., AirCurve 10 VAuto --> AirSense 10 AutoSet For Her). There are some results of quickly tested...

@andrewleech do you mean AirSense 10 Elite? There's nothing to suggest there is any difference in HW between the "AirXXXX 10 YYYYY" units at all (including AirCurve, but not AirStart)....

Haven't looked at that specific unit, but I'd note that it's also on the list of labels (see https://fccid.io/2ACHL-AIR10CD/Label/label-info-2328354) under the FCC approval.

Thanks for your kind words, and even kinder pull requests over the years ;-)

What's the hardware setup? Is this on a ChipWhisperer-Lite XMEGA board (i.e.,  ) or something else with an XMEGA attached? The error **_OSError: XMEGA Command 20 failed: err=1, timeout=1_**...

Finally reviewing (oops) - we try to avoid forcing dependencies as it can break a lot of stuff. Won't accept as-is but leaving open as will rework to avoid setup.py...

On projects - it was always a bit messy for larger captures. We've been looking at changing around some of that, as even ourselves we just use larger NumPy arrays...

Hmm - so this might be related to another issue we've been chasing. Are you using a newer software release? Issue #340 flags another FPGA issue, what you are showing...

Hmm, you're capturing w/ a ChipWhisperer-Lite board right, like stand-alone capture? We could swap that board to confirm it's not the main unit HW if quicker to debug. If so...