coelner
coelner
Same problem here. Both apps don't work. The bootloader disconnects the flasher.
so far this worked for me but I flashed the uart version. Next problem, I can not get any uart reply from the usb pins (I used a ch340G TTL)....
Thanks for your help but I think the device is dead. It does not respond to anything of this.
I tried again with a ch340g and ft2322h but no uart response. Switched TX and RX and applied 5V to the USB connector. I tried also a st-link v2 with...
I tried again with a ch340g and ft2322h but no uart response. I tried also a st-link v2 with gnd and dio, second run was with clk. The battery is...
Ok, thanks. Howe ever the RST does not work with all tries I did, the shortcut between the BAT is working properly. But I am curious why I can't get...
think it was a broken pogo pin. And maybe some of the foam over the RST pad was causing no reliable connection. At least if I run `sudo openocd -d2...
Did you patch this file too: https://github.com/fanoush/ds-d6/blob/master/micropython/DS-D6-adafruit-back-to-desay-sd132v201.zip Currently I can't get into the bootloader successfully, I see only two of the three arrows.
Ok, something is fishy here... I can't upload and the bootloader reaches always the timeout. I tried openocd but I fail early: ``` sudo openocd -d2 -f interface/stlink-v2.cfg -f target/nrf52.cfg...
It is possible to get the client running again, if you change between no proxy and system proxy or vice versa (doesn't matter). I don't know why, but maybe a...