John Rogers
John Rogers
I'd love to know an answer for this too @evilC is there any kind of syntax or documentation available other than the very hard to decipher without being an expert,...
I think this has worked for me! I did get however `/home/yi-hack-v4 # route add default gw 192.168.1.1 route: SIOCADDRT: File exists`
I ran this ``` /home/yi-hack-v4 # ifconfig wlan0 192.168.1.214 netmask 255.255.255.0 up /home/yi-hack-v4 # route add default gw 192.168.1.1 route: SIOCADDRT: File exists /home/yi-hack-v4 # echo nameserver 192.168.1.1 /etc/resolv.conf nameserver...
> My 4-axis mill setup has a gShield running Z and A, which are not speed critical. On X and Y, where I need more power, I use integrated closed...
Thanks How are you managing the alarm circuit? I was thinking it would be very clever/cool to have the alarm circuit trigger a subroutine that would 1. Pause the cut...
Hey > Not so far. It's something I've looked into before as well, by modifying the existing 3-axis post. I wasn't able to get the retraction (Z axis) height working...
I absolutely would have shared it but I found it last night! That is the one, and actually it's the one lower down on that page as it's been tweaked,...
I've since added tweaked this processor myself and added a pull request to get it to be part of G2cores resources folder https://github.com/synthetos/g2/pull/477 Best J
I've got the same issue, My Y-AXIS is fine, My X-AXIS and Z not.
I'm currently getting this error,